(1)任何預拌混凝土在未添加緩凝劑的情況下，都在1小時左右進入初凝狀態，這時再進行混凝土澆注施工將影響混凝土的工程質量。因此全自動攪拌車運送預拌混凝土有其時間控制的輸送半徑。一般控制在1小時以內。從出料到卸料完畢的長時間為90分鐘，且攪拌筒總轉數不大于300轉。如嫌原有的卸料槽不夠長，需另外接長時，請用支柱將接長部分撐住。

(1) Any ready-mixed concrete will enter the initial setting state within about 1 hour without adding retarder, and then the concrete pouring construction will affect the engineering quality of concrete. Therefore, the transportation of ready-mixed concrete by automatic mixer truck has its time-controlled transportation radius. It is generally controlled within 1 hour. The long time from discharging to discharging is 90 minutes, and the total number of revolutions of mixing drum is not more than 300. If the original discharge chute is not long enough and needs to be extended additionally, please support the extended part with a strut.

(2)混凝土出料完畢后，應迅速對拌筒內部進行沖洗。

(2) After the concrete is discharged, the inside of the mixing drum shall be washed quickly.

注意：如不及時沖洗，不僅會造成拌筒內混凝土的粘結，使裝載量減少，進料不暢，還會給機構帶來故障，是事故的誘發因素。務必注意!

Note: if not washed in time, it will not only cause the binding of the concrete in the mixing drum, reduce the loading, and make the feeding not smooth, but also cause the failure of the mechanism, which is the inducing factor of the accident. Be careful!

(3)空車行駛時，拌筒應以與攪動行駛同樣的轉速回轉。

(3) When the truck is running empty, the mixing drum shall rotate at the same speed as the stirring driving.

注意：攪拌車行駛時，如攪拌停止回轉，則拌筒滾道與拌筒托輪上會產生壓痕，并發生異常噪聲。因此，務請注意。

Note: When the mixing truck is running, if the mixing stops rotating, there will be indentation and abnormal noise on the mixing drum raceway and the mixing drum supporting wheel. Therefore, please pay attention.

具體操作步驟如下：

The specific operation steps are as follows:

⑴準備工作準備好三根緊急驅動軟管，卸下接管和接頭蓋。

(1) Prepare three emergency drive hoses, and remove the connecting pipe and connector cover.

⑵故障車(被驅動車)的操作

(2) Operation of faulty vehicle (driven vehicle)

①將故障車的發動機熄火;

① Shut down the engine of the faulty vehicle;

②將緊固螺母(左右各有一個)朝左旋松;

② Unscrew the fastening nuts (one on the left and one on the right) to the left;

③再將旋鈕朝右旋轉，直到不能再旋為止;

③ Turn the knob to the right again until it can no longer be turned;

④將高壓軟管從馬達接頭處卸下;

④ Remove the high-pressure hose from the motor connector;

⑤將緊急驅動軟管接到馬達接頭上;

⑤ Connect the emergency drive hose to the motor connector;

⑥把緊急驅動軟管上的接管與故障車卸下的高壓軟管相接，以防漏油。

⑥ Connect the connecting pipe on the emergency drive hose with the high-pressure hose removed from the faulty vehicle to prevent oil leakage.

⑶救援車(驅動車)的操作

(3) Operation of rescue vehicle (drive vehicle)

①將操作手柄至于空檔位置;

① Set the operating handle to the neutral position;

②將發動機熄火;

② Shut down the engine;

③將高壓軟管從高壓油管處卸下;

③ Remove the high-pressure hose from the high-pressure oil pipe;

④將緊急驅動軟管接到高壓油管上;

④ Connect the emergency drive hose to the high-pressure oil pipe;

⑤用緊急驅動軟管上的接頭蓋將驅動車的高壓軟管蓋起，以防漏油。

⑤ Use the connector cap on the emergency drive hose to cover the high-pressure hose of the drive vehicle to prevent oil leakage.

⑷啟動救援車的發動機。

(4) Start the engine of the rescue vehicle.

⑸將救援車的操作手柄撥至“出料”位置，使故障車內的混凝土排出。

(5) Turn the operating handle of the rescue vehicle to the "discharge" position to discharge the concrete in the fault vehicle.

⑹緊急驅動完畢后，使兩車各自恢復原狀。

(6) After the emergency drive, restore the two vehicles to their original state.

工作時，不得將手伸入旋轉的攪拌筒內，嚴禁將手伸入主卸料溜槽和加長卸料溜槽的連接部位，以免發生事故。以上就是給攪拌車在工作時應注意的問題，相信大家都已經有一定的學習了，希望大家在工作時一定要注意。關注我們http://www.mothernature2u.com了解更多事項！

When working, do not put your hands into the rotating mixing drum. Do not put your hands into the connection part of the main discharge chute and the extended discharge chute to avoid accidents. The above are the problems that should be paid attention to when the mixer is working. I believe that everyone has learned a lot. I hope you must pay attention when working. Follow us http://www.mothernature2u.com Learn more!